PRICING
Factor Rate vs APR: How to Tell What an Advance Really Costs
A factor rate contains no unit of time, which is why it cannot be compared with a bank's annual rate until you have run the conversion yourself.
A funder sends over a number like 1.25. Your bank quoted eleven percent a year. You want to know which one is cheaper, and nobody at either shop is going to tell you, because the two numbers are not measured on the same scale.
Here is the short answer. A factor rate is a multiplier with no unit of time inside it. Multiply the amount advanced by the factor and you have the total you owe. That is the entire formula. An annual percentage rate is a price per year charged on money you are still holding. To compare the two you have to put time back into the factor rate yourself, and when you do, a factor that reads like a quarter of the advance usually turns into something closer to half of it per year. Sometimes a good deal worse.
The arithmetic, on paper
Take a shop that is advanced 40,000 dollars at a factor rate of 1.25. Total payback is 50,000 dollars. The cost of the money is 10,000 dollars. Nothing controversial so far.
Now bring in the number the quote left out: how long you actually have the money. Say the remittance is 1,000 dollars a week and it runs 50 weeks. A year, near enough.
Over that year you never hold 40,000 dollars. You hold 40,000 on the first day and nothing on the last, and somewhere around half of it on average. So the honest question is what 10,000 dollars of cost looks like against roughly 20,000 dollars of money you had the use of.
That is about 50 percent a year.
The headline said 25 percent. The arithmetic says about double, and the arithmetic has not done anything clever. It has only refused to pretend that a balance being paid down every week is the same as a balance sitting still.
The shortcut you can do at the table
Subtract one from the factor rate. Divide by the number of years the term runs. Double the result.
A 1.25 becomes 0.25. Divided by one year it stays 0.25. Doubled, 50 percent.
It is an approximation, and a compliance officer will happily tell you it is not the formula in the regulation. It is close enough to tell you which category of product you are looking at, which is the decision in front of you.
Why the term is the whole ballgame
Run that same 1.25 over six months instead of a year. The cost is still 10,000 dollars. You still pay back 50,000. Nothing about the quote has changed by a single character.
But you had the money for half as long, so the annualized cost is roughly twice what it was. Same factor rate. Same dollars out the door. Double the price.
This is what catches owners comparing two offers side by side. A 1.22 over four months is more expensive than a 1.35 over fourteen. Rank the offers by factor rate and you will pick the wrong one, and the funder quoting the lower factor is aware of that.
And the short term does a second thing, which is to raise the daily or weekly debit. That belongs to a different conversation about cash flow rather than price, but the two are welded together in practice: the cheapest-looking factor usually arrives attached to the fastest payback.
What the factor rate leaves out
The multiplier prices the advance. It does not price everything that moves between you and the funder.
- An origination, underwriting or administrative fee, usually deducted before the wire goes out, so less arrives than the contract says was advanced. Quoted 40,000 and 38,600 lands? Then you are paying 50,000 for the use of 38,600, and every number above gets worse.
- ACH or lockbox fees charged per debit. On a daily remittance that is a charge every business day, which behaves very differently from the same fee on a monthly loan payment.
- Rejection and insufficient funds fees when a debit bounces.
- A default rate or an acceleration clause, which rewrites the arithmetic the moment something slips.
Ask for the net funded amount in dollars, the figure that will actually be sitting in the account. Run everything off that number rather than off the headline on the term sheet.
Early payoff does not work the way you expect
On a term loan, paying early saves you interest. Interest accrues over time, you stopped the clock, you keep the difference.
A factor rate has no clock. The 50,000 was fixed on the day you signed. Pay it down in three months instead of twelve and you still owe 50,000, unless the contract carries a specific early payoff provision in writing with the discounted figures stated in it.
Some contracts do. Plenty do not. A sales rep saying they will work with you on early payoff is worth exactly what you paid for it. Read the prepayment section, and if there is no prepayment section, you have your answer.
The effect is harsh. Pay a 1.25 back in three months and you have handed over 10,000 dollars for a quarter of a year on a 40,000 dollar advance, which annualizes into a figure most owners would refuse outright if it were printed across the first page in the same type size as the factor rate.
Where a rate is now required on the page
A number of states have passed commercial financing disclosure laws requiring a funder to show an estimated annual percentage rate before you sign, covering sales-based financing and factoring as well as ordinary loans. California and New York each have one. The particulars differ between them, and other states have gone their own way, some requiring a rate, others requiring only the total dollar cost and the term.
So the first thing to check is whether the state your business sits in requires that disclosure at all. If it does, ask for the form. You are not asking for a favor, and a funder who will not hand over a disclosure their own state requires has told you something useful about the rest of the relationship before you have signed anything.
If your state has no such law, you are doing the conversion yourself, with the shortcut above and the net funded figure in place of the headline.
One last thing, because it matters to how you read all of this. A factor rate is high because the product is priced for a category of risk rather than for you personally. The funder is underwriting deposits and card volume over a short window, moving in days, often with very little between them and a total loss if the business stops. Fast money with thin underwriting costs more than slow money with deep underwriting. That part is coherent and there is no scandal in it.
What is incoherent is quoting that price in a unit that conceals how much more. A 1.25 is a real price for a real product, and there are owners for whom it is the right trade, because their decision turns on speed and on what the money is about to do. Printed as an annual rate, those owners would still sign. The ones who would walk are the ones for whom it never worked in the first place, and they are exactly the ones the unit is hiding it from.
Run the conversion. Then decide.
Common questions
how do I convert a factor rate to an APR?
Subtract one from the factor rate, divide by the length of the term in years, then double the result. A 1.3 paid back over one year is 0.3 divided by one, doubled, so roughly 60 percent. The doubling is there because you are paying the balance down the entire time and never hold the full advance for the full term.
is a lower factor rate always the cheaper offer?
No, because the factor rate says nothing about how long you have the money. A 1.22 repaid in four months costs more per year than a 1.35 repaid over fourteen months. Rank offers by annualized cost and by the net amount that actually lands in your account, never by the multiplier on the term sheet.
does paying off a merchant cash advance early save money?
Only when the contract says so in writing. The total was fixed by the factor rate on the day you signed and there is no interest clock to stop. Look for a named prepayment or early payoff section with real discounted figures in it, and treat a verbal promise as absent if it is missing from the document.